Detroit Series 60 Valve Adjustment Specs. Q&A Detroit Series 60 12.7 Valve Adjustment, Rocker Arm & Jake Brake Detroit Series 60 12.7L Valve Adjustment Chart; Series 60 - Section 13.4 Valve Lash for the Series 60G Engine; Series 60 - Section 13.2 Valve Lash, Injector Height (Timing) and Jake Brake® Lash Adjustments; Series 60 - Section 13.3 Engine Tune-Up Procedures for the Series 60G Engine; Series 60 - Section 13.1 Engine Tune-Up Procedures See Figure "Valve Clearance Adjustment Series 60G Engines".
Detroit series 60 in frame rebuild (part 2) valve cover removal. YouTube from www.youtube.com
To adjust the intake valves, insert a 0.203 mm (.008 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm Accurate adjustment of clearance between valve buttons, intake and exhaust valves is important if maximum performance and economy are to be obtained
Detroit series 60 in frame rebuild (part 2) valve cover removal. YouTube
To adjust the intake valves, insert a 0.203 mm (.008 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm Intake valve clearance and fuel injector height are adjusted using an adjusting set screw and locknut located at the valve or injector end of the rocker arm Refer to "Removal and Cleaning of One-piece Rocker Cover for Diesel Engines Only" for one-piece,
Lubrication System Detroit Diesel Troubleshooting Diagrams. *** Adjust the valves and N3 fuel injector settings as follows: 1 To adjust the intake valves, insert a 0.279 mm (0.011 in.) feeler gage between the tip of the valve stem and the valve button at the end of the rocker arm
Detroit 60 Series Overhead Adjustment Chart. Note that on engines with Jake Brake, measure valve lash and injector height before removing any brake housings The timing circle can be started with any cylinder